Skip to content
Home/Answers/Getting started
CANADA RADIANT / Getting started

Getting started: Radiant Floor vs Radiators

Getting started: Compare response time, comfort, retrofit difficulty and cost.

Updated 2026-11-19About 3 min
Affiliate disclosure: some outbound links go to commercial partners. We currently pass no tracking parameters, so we earn no commission from them; if that changes, this page will say so.
Quick answer

Getting started: Compare response time, comfort, retrofit difficulty and cost. Start depends on floor/heat source/budget.

Why it matters

Start with Floor, Heat source; the cost and outcome of getting started follow from those.

Step by step

  1. Run a room-by-room heat loss calculation.
  2. Check whether the floor can host tubing.
  3. Choose the heat source from the required water temperature.
  4. Then plan zoning and controls.

Common mistakes

  • Skipping the heat loss calculation.
  • Spacing set too wide.
  • Missing insulation below.
  • Using a heat source that cannot reach the water temperature.

Checklist

  • Heat loss/floor/water temp/zoning/permits.
  • Floor section drawing.
  • Heat source spec.
  • Three quotes.
  • Control plan.

Who it is for

If you are deciding between two models, put Floor. and Heat source. in one table and compare on the same basis.

Key facts

  • Floor.
  • Heat source.
  • Budget.

FAQ

Getting started: Radiant Floor vs Radiators

Getting started: Compare response time, comfort, retrofit difficulty and cost. Start depends on floor/heat source/budget.

What should I check before buying a Getting started?

Start depends on floor/heat source/budget. Key checks: Floor.; Heat source..

Is a Getting started worth it?

Depends on use, budget and upkeep; a Getting started is not automatically better because it costs more.

Source: Natural Resources Canada

Top picks

ProductBest forPrice
Radiant InstallerInstallHighCompare options
BoilerHeat sourceHighCompare options
InsulationInsulationLowCompare options

Sources